46 thoughts on “Customer states: i think i hit something!”
  1. Avataaar/Circle Created with python_avatars Big Al says:

    No anti seize?

  2. Avataaar/Circle Created with python_avatars Big Al says:

    Well done again….Click

  3. Avataaar/Circle Created with python_avatars Eric Berlin says:

    “Reeeeeeee!” Just for good measure. 🤣👍

  4. Avataaar/Circle Created with python_avatars tr5317 says:

    I can never get the CV joints to snap off, so I found a clamp that goes around the CV housing, and my slide hammer threads right into it. Never had a problem since, and I'm able to work within the wheel well.

  5. Avataaar/Circle Created with python_avatars Isaac Camario says:

    or you could actually use a rubber mallet and smack the axle in

  6. Avataaar/Circle Created with python_avatars maurice goodwin says:

    never hit two hammer faces together they could splinter believe me i know

  7. Avataaar/Circle Created with python_avatars TommyG1814 says:

    She was lucky, ,,,nice job Ray

  8. Avataaar/Circle Created with python_avatars Peter Bland says:

    Was a DUI involved?

  9. Avataaar/Circle Created with python_avatars Grabber5.0 says:

    I knew my air hammer was under-utilized, but Ray's channel has helped me see what I'm missing. 👍🏻

  10. Avataaar/Circle Created with python_avatars Greg W says:

    umm, Ray, You said Yea, instead of Click.

  11. Avataaar/Circle Created with python_avatars Richard Zona says:

    The only thing I didn't like was that the new axle came with a new seal that I feel you should of put in the transaxle before installing the axle. I had an axle replaced on my Lexus and they didn't bother replacing the seal either. Now 2 years later I have to put up with transaxle problems because the old seal was leaking and I had no way of checking the trans fluid because Lexus does not have a trans dip stick.. I Mean what would of took you 5 minutes more to pop out the old seal and tap the new seal in.

  12. Avataaar/Circle Created with python_avatars I love fabric and flowers says:

    After watching a couple of your videos, I am now firmly convinced that being a mechanic and a doctor are similar. This is because when a customer does the equivalent of shoving something in their bum and needing to go to the doctor to get it taken out they are telling the same lies to the Mechanic. Oh, I think I hit something. Yes, you sure did, fool, you fucked something right up your rear end.

  13. Avataaar/Circle Created with python_avatars randy beard says:

    I think I Hit Something, You Think….

  14. Avataaar/Circle Created with python_avatars John Thorpe says:

    Wonder why he didn't suggest having the rotor resurfaced while he basically had it apart??

  15. Avataaar/Circle Created with python_avatars Cheezehd Glen says:

    I have watched a bunch of your videos and learned a lot. We need to know the approximate bill. How about $ parts + labor Thanks, Glen

  16. Avataaar/Circle Created with python_avatars Evan Caswell says:

    Never hit a hammer with a second hammer; always use a third hammer to hit the second hammer to hit the first hammer; saved my life every day

  17. Avataaar/Circle Created with python_avatars Frank Jacobson says:

    Watching ray work is like spending a day with a mechanic, shadowing tasks. Ray is a Hella nice guy and funny sometimes to boot! Keep it up ray, Love it!

  18. Avataaar/Circle Created with python_avatars Oot Oot says:

    [this comment has been drowned out by nearby impact gunning]

  19. Avataaar/Circle Created with python_avatars Les Rocheuses says:

    Pretty car!

  20. Avataaar/Circle Created with python_avatars Dave Colvin says:

    Forgot top off tranny fluid

  21. Avataaar/Circle Created with python_avatars Don's Junkmail says:

    Pretty blue car

  22. Avataaar/Circle Created with python_avatars R W says:

    How do you like the Rigid impacts? I am torn between those and Milwaukee Fuel.

  23. Avataaar/Circle Created with python_avatars Dee Loc says:

    She didnt hit the curb she smoked it

  24. Avataaar/Circle Created with python_avatars Artimus Protensor says:

    Hurry, hurry, hurry! Get your gen-yoo-wine, one-hundred-percent authentic Rainman Ray action figures, now with More Prybar Action!

  25. Avataaar/Circle Created with python_avatars Steve Farris says:

    I believe she hit it and backed up, hit it again, drove forward, hit it again, backed up, hit it again. I'm sure u get it now. Lol

  26. Avataaar/Circle Created with python_avatars JC Team says:

    Bye bye miss American pie…

  27. Avataaar/Circle Created with python_avatars Trump 2024 says:

    Guess I'm lucky. My wife doesn't drive and doesn't want too

  28. Avataaar/Circle Created with python_avatars TheOnespeedbiker says:

    You tore into that box of parts like a kid on Christmas morning 🤣

  29. Avataaar/Circle Created with python_avatars Yora says:

    For a wheel that was half ripped off the car, this repair looks pretty easy.

  30. Avataaar/Circle Created with python_avatars Paul Belcher says:

    Ray, like watching someone else diagnose and repair, it's quite therapeutic, however in this video I'm saddened to see you replace the complete driveshaft when a boot replacement kit would have been suffice, no need to struggle taking it out of the gearbox and loosing the oil.

  31. Avataaar/Circle Created with python_avatars Timothy says:

    "IN THE LITTLE WRECKED BLUE NISSAN" LOL

  32. Avataaar/Circle Created with python_avatars R Phuche says:

    ha ha I hit something Translation: I don't know what I hit, cuz I was texting and not paying attention. Might wanna check for flesh, bones and blood while you're at it

  33. Avataaar/Circle Created with python_avatars john ann says:

    She "thinks" she hit something ???

  34. Avataaar/Circle Created with python_avatars Tryck Spot says:

    How in the world do you run over something that does enough damage to destroy your suspension that bad but not blow the tires or damage the rims or body? thats wild.

  35. Avataaar/Circle Created with python_avatars SuGGoz says:

    Ray, a question? How much would that whole job cost? Why i ask is i live in Sweden and it would be fun to hear if it's more or less here. Thanks in advance. Great videos and great work.Thanks.

  36. Avataaar/Circle Created with python_avatars Jos de Koning says:

    Adding some transmissionoil?

  37. Avataaar/Circle Created with python_avatars Judd Hoeft says:

    YOU DO GREAT WORK . BUT IHAVE TO COMMENT ABOUT STRIKING TWO HAMMER FACES TOGETHER . NOT A SAFE THING TO DO . TRY TO USE A BRASS DRIFT.

  38. Avataaar/Circle Created with python_avatars CASKET BLACK says:

    Wow!!

  39. Avataaar/Circle Created with python_avatars fred flintstoner says:

    Mrs Richards: "I paid for a room with a view!"
    Basil: (pointing to the lovely view) "That is Torquay, Madam."
    Mrs Richards: "It's not good enough!"
    Basil: "May I ask what you were expecting to see out of a Torquay hotel bedroom window? Sydney Opera House, perhaps? the Hanging Gardens of Babylon? Herds of wildebeest sweeping majestically past?…"
    Mrs Richards: "Don't be silly! I expect to be able to see the sea!"
    Basil: "You can see the sea, it's over there between the land and the sky."
    Mrs Richards: "I'm not satisfied. But I shall stay. But I expect a reduction."
    Basil: "Why?! Because Krakatoa's not erupting at the momentt?

  40. Avataaar/Circle Created with python_avatars Peter Harms says:

    Two hardened hammer faces together!!!! I still have a sliver of steel in my hand from a similar practice when I was sixteen, I’m now seventy.
    I never had it removed as, it has reminded me every day that it could have just as easily been in my eye.

  41. Avataaar/Circle Created with python_avatars Dennis Coughlin says:

    Use a ratchet bro

  42. Avataaar/Circle Created with python_avatars Art Gale says:

    Beating down the bearing surfaces of both cv joints with an air hammer?
    That can't be good.

  43. Avataaar/Circle Created with python_avatars Eddy Hawman says:

    Oh no! No pouring! What am I gunna do? I can't live without pouring! Oh my God, Oh my god, oh my god, is this the end………….

  44. Avataaar/Circle Created with python_avatars Roger Morris says:

    hey Rainman have you lost your mind ???? Hammer on Hammer dead blow WTF man?

  45. Avataaar/Circle Created with python_avatars Brian C says:

    i wish they would state what the approximate repair bill was.

  46. Avataaar/Circle Created with python_avatars jacob Burnside says:

    Am I the only one whose curious as to how a rotor can rust that quickly…

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.